Browse Prior Art Database

Printer Finishing MIB (RFC3806)

IP.com Disclosure Number: IPCOM000029053D
Original Publication Date: 2004-Jun-01
Included in the Prior Art Database: 2004-Jun-15

Publishing Venue

Internet Society Requests For Comment (RFCs)

Related People

R. Bergman: AUTHOR [+3]

Abstract

This document defines a MIB module for the management of printer finishing device subunits. The finishing device subunits applicable to this MIB are an integral part of the Printer System. This MIB applies only to a Finisher Device that is connected to a Printer System.

This text was extracted from an ASCII text file.
This is the abbreviated version, containing approximately 3% of the total text.

Network Working Group                                         R. Bergman

Request for Comments: 3806                    Hitachi Printing Solutions

Category: Informational                                         H. Lewis

                                                         IBM Corporation

                                                             I. McDonald

                                                         High North Inc.

                                                               June 2004

                         Printer Finishing MIB

Status of this Memo

   This memo provides information for the Internet community.  It does

   not specify an Internet standard of any kind.  Distribution of this

   memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2004).

Abstract

   This document defines a MIB module for the management of printer

   finishing device subunits.  The finishing device subunits applicable

   to this MIB are an integral part of the Printer System.  This MIB

   applies only to a Finisher Device that is connected to a Printer

   System.

Bergman, et al.              Informational                      [Page 1]

RFC 3806                 Printer Finishing MIB                 June 2004

Table of Contents

   1.  Introduction. . . . . . . . . . . . . . . . . . . . . . . . .   3

       1.1.  Scope . . . . . . . . . . . . . . . . . . . . . . . . .   3

       1.2.  Rational. . . . . . . . . . . . . . . . . . . . . . . .   4

       1.3.  The Internet-Standard Management Framework. . . . . . .   4

       1.4.  Read-Write Objects. . . . . . . . . . . . . . . . . . .   4

   2.  Terminology . . . . . . . . . . . . . . . . . . . . . . . . .   5

       2.1.  General Terminology . . . . . . . . . . . . . . . . . .   5

       2.2.  Process Specific Terminology. . . . . . . . . . . . . .   9

   3.  Finisher Subunits Integrated into the Printer Model . . . . .  12

   4.  Finishing Specifications. . . . . . . . . . . . . . . . . . .  12

       4.1.  Multiple finDeviceTable Entries . . . . . . . . . . . .  13

       4.2.  Implicit Parameters . . . . . . . . . . . . . . . . . .  13

             4.2.1.  FinPunchPatternTC . . . . . . . . . . . . . . .  14

             4.2.2.  FinPunchHoleTypeTC, punchHoleSizeMaxDim,

                     punchHoleSizeMinDim . . . . . . . . . . . . . .  15

   5.  The Attribute Mechanism . . . . . . . . . . . . . . . ....