Browse Prior Art Database

Diameter Support for the EAP Re-authentication Protocol (ERP) (RFC6942)

IP.com Disclosure Number: IPCOM000227678D
Original Publication Date: 2013-May-01
Included in the Prior Art Database: 2013-May-11
Document File: 36 page(s) / 36K

Publishing Venue

Internet Society Requests For Comment (RFCs)

Related People

J. Bournelle: AUTHOR [+5]

Abstract

Cao, et al. [RFC6696] defines the EAP Re-authentication Protocol (ERP). It consists of the following steps:

This text was extracted from an ASCII text file.
This is the abbreviated version, containing approximately 7% of the total text.

Internet Engineering Task Force (IETF)                      J. Bournelle Request for Comments: 6942                                     L. Morand Category: Standards Track                                    Orange Labs ISSN: 2070-1721                                               S. Decugis                                                            INSIDE Secure                                                                    Q. Wu                                                                   Huawei                                                                  G. Zorn                                                              Network Zen                                                                 May 2013

      Diameter Support for the EAP Re-authentication Protocol (ERP)

Abstract

   The EAP Re-authentication Protocol (ERP) defines extensions to the    Extensible Authentication Protocol (EAP) to support efficient    re-authentication between the peer and an EAP Re-authentication (ER)    server through a compatible authenticator.  This document specifies    Diameter support for ERP.  It defines a new Diameter ERP application    to transport ERP messages between an ER authenticator and the ER    server, and a set of new Attribute-Value Pairs (AVPs) that can be    used to transport the cryptographic material needed by the    re-authentication server.

Status of This Memo

   This is an Internet Standards Track document.

   This document is a product of the Internet Engineering Task Force    (IETF).  It represents the consensus of the IETF community.  It has    received public review and has been approved for publication by the    Internet Engineering Steering Group (IESG).  Further information on    Internet Standards is available in Section 2 of RFC 5741.

   Information about the current status of this document, any errata,    and how to provide feedback on it may be obtained at    http://www.rfc-editor.org/info/rfc6942.

 Bournelle, et al.            Standards Track                    [Page 1]
 RFC 6942                Diameter ERP Application                May 2013

 Copyright Notice

   Copyright (c) 2013 IETF Trust and the persons identified as the    document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal    Provisions Relating to IETF Docu...