Browse Prior Art Database

PIM Join Attributes for Locator/ID Separation Protocol (LISP) Environments (RFC8059)

IP.com Disclosure Number: IPCOM000248908D
Original Publication Date: 2017-Jan-01
Included in the Prior Art Database: 2017-Jan-21
Document File: 18 page(s) / 20K

Publishing Venue

Internet Society Requests For Comment (RFCs)

Related People

J. Arango: AUTHOR [+4]

Abstract

The construction of multicast distribution trees where the root and receivers are located in different LISP sites [RFC6830] is defined in [RFC6831]. Creation of (root-EID,G) state in the root site requires that unicast LISP-encapsulated Join/Prune messages be sent from an ETR on the receiver site to an ITR on the root site. The term "EID" is short for "Endpoint ID".

This text was extracted from an ASCII text file.
This is the abbreviated version, containing approximately 14% of the total text.

Internet Engineering Task Force (IETF)                         J. Arango Request for Comments: 8059                                     S. Venaas Category: Experimental                                     Cisco Systems ISSN: 2070-1721                                              I. Kouvelas                                                     Arista Networks Inc.                                                             D. Farinacci                                                              lispers.net                                                             January 2017

                           PIM Join Attributes          for Locator/ID Separation Protocol (LISP) Environments

Abstract

   This document defines two PIM Join/Prune attributes that support the    construction of multicast distribution trees where the root and    receivers are located in different Locator/ID Separation Protocol    (LISP) sites.  These attributes allow the receiver site to select    between unicast and multicast underlying transport and to convey the    RLOC (Routing Locator) address of the receiver ETR (Egress Tunnel    Router) to the control plane of the root ITR (Ingress Tunnel Router).

Status of This Memo

   This document is not an Internet Standards Track specification; it is    published for examination, experimental implementation, and    evaluation.

   This document defines an Experimental Protocol for the Internet    community.  This document is a product of the Internet Engineering    Task Force (IETF).  It represents the consensus of the IETF    community.  It has received public review and has been approved for    publication by the Internet Engineering Steering Group (IESG).  Not    all documents approved by the IESG are a candidate for any level of    Internet Standard; see Section 2 of RFC 7841.

   Information about the current status of this document, any errata,    and how to provide feedback on it may be obtained at    http://www.rfc-editor.org/info/rfc8059.

Arango, et al.                Experimental                      [Page 1]
 RFC 8059        PIM Join Attributes for LISP Environments   January 2017

 Copyright Notice

   Copyright (c) 2017 IETF Trust and the persons identified as the    document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal    Provisions Relating to IETF Documents    (http://trustee.ietf.org/license-info) in effect on the date of    publication of...